Fiber Optics LED Displays Lenses Epoxy Adhesive, Fast Cure, 2 Part, F131, 2.5gm

Description

Technical Product Bulletin
HIGH TG ROOM TEMPERATURE CURE FIBER OPTIC ADHESIVE
PRODUCT DESCRIPTION:
AA-BOND F131
is two parts fiber-optic adhesive used for terminating all types of fiber-optic connectors as well as LED displays, lenses and other optical components.
AA-BOND F131
produces a typical Tg of 95 °C thus meeting specification requirements of connector’s manufacturers.
AA-BOND F131
is two part, low viscosity
system can be cured at room temperature or as fast as 15 minutes at 90 °C.
GENERAL  PROPERTIES:
Appearance
Clear
Cure Type
Room Temperature or Heat cure
Benefits
Low viscosity
Mix Ratio by weight
100:30 / Resin:Hardener
Typical Applications
ALL types of fiber-optic connectors as well as LED displays, lenses and other optical components.
UNCURED PROPERTIES:
Viscosity @ 25 °C
1,800 ±200
@Temperature 25.0 °C, 77.0 °F
Thixotropic Index
1.0
Specific Gravity, mixed,  g/cc
1.21
CURE SCHEDULE:
15 minutes
@ 90°C; 1 drop applications
1 Hour
@ 65°C
18 Hours
@ 25°C
CURED PROPERTIES:
Hardness, Shore D
77
Lap shear strength, psi
3600
(Alum to Alum)
Volume Resistivity ohm-cm
1.00e+11
Izod Impact, Notched
0.220
ft-lb/in
ELECTRICAL PROPERTIES:
Volume Resistivity
1.00e+11
ohm-cm
THERMAL PROPERTIES:
Operating Temperature
-60 to 120 °C
Glass Transition Temp, Tg
95.0 °C   203 °F
GENERAL INFORMATION:
For safe handling information on this product, consult the Material Safety Data Sheet, (MSDS).
HOW TO USE:
1)
Carefully clean and dry all surfaces to be bonded.
2)
Apply this completely mixed adhesive to the prepared surfaces, and gently press these surfaces together. Contact pressure is adequate for strong, reliable bonds;
however, maintain contact until adhesive is completely cured.
3)
Some separation of components is common during shipping and storage. For this reason, it is recommended that the contents of the shipping container be
thoroughly mixed prior to use.
4)
Some ingredients in this formulation provided may crystallize when subjected to low temperature storage. A gentle warming cycle of 52°C for 30 minutes prior
to mixing components may be necessary. Crystallized epoxy components do not react as well as liquid components and should be re-dissolved prior to use for
best
results.
AVAILABILITY:
This epoxy can be supplied in various different packages.
Froo www.froo.com | Froo Cross Sell, Free Cross Sell, Cross promote, eBay Marketing, eBay listing Apps, eBay Apps, eBay Application